Two optically isolated inputs with independent terminals. Inputs are fully isolated from system ground.
- 5V - Consumes 30mA
This Tibbit is optimized for the nominal input voltage of 24V. If no external resistor is added these inputs activate at about 13V. Forward current should not exceed 10mA, and this caps the maximum input voltage at around 30V. Add external resistors if you need to apply higher input voltage.
Combine this Tibbit with terminal block devices — #20 (nine terminal blocks) or #21 (four terminal blocks).
There are two green LEDs which are connected to two control lines. LEDs light up for the LOW state of control lines (i.e. when current passes through the diodes of the opto-couples).